Machining & Assembly · Component review guide · Litian Yunde
Overlap and gap need separate controls. Original explanatory schematic; not to scale and not a product test result.
A bonded carbon fiber joint should define both overlap and the adhesive gap. More overlap is not a complete joint specification, and a visually thin glue line is not automatically better. Use the adhesive supplier’s instructions and validate the actual joint configuration.
Draw the joint section
Show the adherends, bond area, gap control and any fillet or adhesive exclusion zone. Include the direction and type of loading for engineering review. A lap-joint sketch should distinguish the structural bond from cosmetic edge finishing. The design authority should establish dimensions and acceptance limits; a procurement article cannot supply universal overlap or bondline values.
Connect geometry with the bonding process
Clarify how parts are located without unintentionally squeezing the adhesive out of the intended region. Record surface preparation, adhesive identification and curing instructions in the approved process. WEST SYSTEM’s preparation guidance emphasises suitable clean, dry, prepared surfaces for its epoxy systems. Use the selected adhesive manufacturer’s requirements for the actual materials rather than transferring a generic sanding recipe.
Make evidence match the joint
Specify what can be checked directly and what needs process records or a representative test. External squeeze-out alone does not prove complete internal coverage. A test coupon can support a process review, but its geometry and preparation need to represent the relevant variables. Keep the sample report attached to the exact joint revision and adhesive configuration.
Example: a bonded mounting foot
A foot sits at the correct location but tilts as it is clamped during cure. The next fixture controls its position and the specified adhesive gap independently. The inspection package records fixture setup, adhesive batch and the agreed checks. The fix is a controlled assembly method, not an instruction to apply more adhesive by eye.
此为示例场景，并非客户案例或已报告的生产结果。.
下单前需确认的细节
| 评论对象 | 记录以示同意 |
|---|---|
| Joint definition | Overlap, gap, load direction and adhesive boundaries. |
| Process record | Preparation, adhesive identity and cure conditions. |
| Location control | Fixture contacts and gap-control method. |
| Verification | Inspection coverage and representative test requirements. |
买家常问的问题
Does more adhesive always strengthen the joint?
No. Follow the qualified joint design and adhesive process.
Can squeeze-out be the only acceptance check?
It confirms adhesive is visible at an edge, not that the internal joint meets all requirements.
技术背景及相关阅读资料
背景资料： WEST SYSTEM: Surface Preparation. 上述项目检查清单和示例仅供编辑参考；本参考资料并不对利天云德的组件进行认证。.