Machining & Assembly · Component review guide · Litian Yunde
Thread fit is one part of the joint. Original explanatory schematic; not to scale and not a product test result.
Tightening torque, pull-out resistance and repeated assembly performance describe different aspects of a threaded insert. Specify which loads and service conditions matter, then agree representative tests. A thread gauge result alone does not qualify the insert’s attachment to the composite.
Define the complete insert assembly
Identify the insert, surrounding laminate or local reinforcement, installation method and mating fastener. Include thread engagement and any bearing surfaces in the drawing. A catalogue value for a metal insert does not establish the capacity of its installed composite interface. The relevant assembly includes the local part geometry and the process used to retain the insert.
Separate installation from operational loading
An installation torque may concern fitting the insert; a fastening torque concerns the mating screw. Neither is automatically the permitted service load. State whether the joint sees axial pull, rotation, bending or repeated removal. The responsible engineer should set the test conditions and acceptance criteria for the application rather than selecting values from a visually similar component.
Plan inspection after the relevant duty
Record thread condition, insert movement and the surrounding surface after the agreed test. If repeated servicing matters, define the representative fastening sequence and inspection points. Preserve failed samples for investigation where appropriate. A part that passes an initial fit check may still require separate testing before its intended service use.
Example: an electronics cover removed for maintenance
The cover’s inserts accept screws during initial assembly, but the product is expected to be opened repeatedly. The buyer specifies the fastener, engagement and maintenance duty, then requests a representative repeated-assembly evaluation. The report distinguishes the screw’s fit from insert rotation and local condition. It does not generalise the result to every insert size.
此为示例场景，并非客户案例或已报告的生产结果。.
下单前需确认的细节
| 评论对象 | 记录以示同意 |
|---|---|
| Hardware identity | Insert, screw, engagement and bearing arrangement. |
| Local construction | Drawing revision and reinforcement/installation detail. |
| Duty and load | Pull, rotation, service cycles and environment. |
| Acceptance evidence | Test configuration, outcomes and post-test inspection. |
买家常问的问题
Does a good thread gauge check prove pull-out strength?
No. It checks a thread condition, not the installed joint’s load capacity.
Should a failed insert simply be bonded back in?
Only under an approved repair or rework instruction with appropriate reinspection.
技术背景及相关阅读资料
背景资料： Hexcel：预浸料技术. 上述项目检查清单和示例仅供编辑参考；本参考资料并不对利天云德的组件进行认证。.